Sometimes it’s nice to see a part of the car looking good even when everything else still looks rough. That was the reason for getting the top half of the inlet manifold powder coated in chrome effect.

Inlet manifold

Before and after…

Coated manifold

I think it looks pretty good, so thanks to Bret at Vectis Powder Coating for a job well done.

The lower half of the manifold is being machined by SeaTek Engineering in Cowes. This will re-align the water outlet to take a more direct route to the heater matrix.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.